@ThomasPBX wrote:
I'm running Asterisk FreePBX 13.0.190.7 on a RPI2 Model B. It is working well; it handles my GV VoIP and a Lenny script (ultimate telemarketer torture chamber). I'm impressed with the low cost and fantastic features.
I have a special application where I need Asterisk to play a custom disconnect tone when SIP extensions hang up on calls to one of the trunks (a PSTN line handled by a Cisco SPA8800 FXO/FXS adapter).
I edited indications.conf and changed several entries to see if I can influence the call progress tones. In my experimentation with editing the file I discovered two things:
After reloading indications.conf (CLI: config reload indications.conf) the call progress tones do not change.
Restarting asterisk overwrites my edits and restores the indications.conf file to its original state. Specifically, I use Country Indication Tones = United States in the admin->Advance-settings. So the tones are restored to the North American format.
In my searching I found many discussion on altering the call progress tones by editing the indications.conf file. I also read that the edits will be overwritten by Asterisk 13 in a reload. So I am lost on how to make the edits work as intended and remain permanent.
BTW, ideally only the PSTN line would have the custom call progress tone upon disconnected SIP calls. More to the point, can the call progress tone be configured in the dial plan for the trunk line? If that is not possible then no worries, it would be Ok if all SIP extensions heard the same custom disconnect tone.
- Thomas
Posts: 1
Participants: 1