Help moving FreePBX to new hardware - dahdi module not working

@allan34 wrote:

The dahdi config web page stops working when the dahdi card is not found.

Testing a failover scenario, i.e. moving FreePBX to a new system but with different hardware.

Restored backup on new hardware, and after reconfiguring the network cards can connect to the GUI

The original system has 1 pri card. Not surprisingly this is not found on the new system. The pri card (sangoma a101de) is at a different pci bus address on the destination system.

So I followed what was needed to originally install the card, i.e. disable the dahdi module, run wancfg manually, then re-enabled the dahdi module.

But still the dahdi config GUI page is still stuck. Only the restart button works.

image.png803x387 30.8 KB

Any ideas? Is it possible to wipe the dahdi config from the system? And start new but without removing the complete config.

lspci shows the card

08:04.0 Network controller: Sangoma Technologies Corp. A200/Remora FXO/FXS Analog AFT card

And

dahdi_hardware
pci:0000:08:04.0 wanpipe- 1923:0040 Sangoma Technologies Corp. A200/Remora FXO/FXS Analog AFT card

And wancfg finds it....
/usr/sbin/wancfg_dahdi
...

Would you like to generate /etc/asterisk/chan_dahdi.conf
1. YES
2. NO
[1-2]:1

---

Configuring T1/E1 cards [A101/A102/A104/A108/A116/T116]

---

A101 detected on slot:4 bus:8

Software Installed:

fwconsole --version
FW Console - FreePBX Utility version 13.0.190.7

asterisk -V
Asterisk 11.25.1

Thanks
Allan

Posts: 2

Participants: 2

Read full topic