@theseizure wrote:
I have my RasPBX running on my Raspberry Pi3 perfectly with Ethernet. I also have Wifi setup and it's connecting properly and has an IP. I can access the Freepbx admin gui from either Lan or Wifi. I'm also able to disconnect my LAN, and soley on my WiFi browse the internet and download different repositories on the internet.
If I disconnect my LAN cable, I can still SSH and access the FreePBX admingui via WiFi IP. However my FreePBX will stop registering with my SIP Trunk. In the logs I will see "Registering with SIP....Timed out...retry" over and over until it gives up. If I plug my LAN cable back in, it immediately registers again.
SIP DEBUG below
-----------Retransmitting #5 (NAT) to 204.11.192.22:5080:
REGISTER sip:sip provider:5080 SIP/2.0
Via: SIP/2.0/UDP 192.168.1.128:5060;branch=z9hG4bK1b6a4062;rport
Max-Forwards: 70
From: ;tag=as1a4fab0f
To:
Call-ID: 489bdd6710df70076dd4a9a2092631d7@127.0.1.1
CSeq: 956 REGISTER
Supported: replaces
User-Agent: FPBX-13.0.190.19(13.13.1)
Authorization: Digest username="12345678", realm="sip provider", algorithm=MD5, uri="sip:sip:sip provider", nonce="ddf539763eb270ddfd321e7abcbe01cd", response="afcd499f24948c44fb47d562a1c7787e"
Expires: 120
Contact:
Content-Length: 0[2017-03-28 18:54:30] NOTICE[1773]: chan_sip.c:15747 sip_reg_timeout: -- Last Registration Attempt #10 failed, Giving up forever trying to register '12345678@sip provider'
Really destroying SIP dialog '489bdd6710df70076dd4a9a2092631d7@127.0.1.1' Method: REGISTER
To add some difficulty to the matter I cannot go to Freepbx Admin Gui and go to Admin - System Admin and Network to change the settings becausethis Module is not available on RasPBX based on FAQ
Can I install System Admin or any other module that requires Zend Guard Loader?
Unfortunately no. Zend Guard Loader is closed source and only available on x86 platforms.I also checked if I can reach my provider
root@xxxxx#: nc -uv callcentric.com 5060
Connection to callcentric.com 5060 port [udp/sip] succeeded!I've tried going to my Chan_SIP settings and binding and change it from 0.0.0.0 to my WiFi ip address it's the same problem
Is there some CLI I can do to change the network settings to FreePBX can route in and out using WiFi, so I can run my Raspbx primarily on Wifi?
Posts: 1
Participants: 1