@MacsOffice wrote:
Just asking… I’ve resigned myself to buy an appliance as I can’t make FreePBX work reliably and potentially for this reason - but this may apply in either case so I’m asking.
My desired config has 3 ETH ports, Phones, Gateway and business lan.
When I have all these configured AND CONNECTED the system works quite well, dial an extension and it rings, dial a ring group and that rings too.Brought it on location and I have a gateway problem - it cant dial out. Working on that with provider but what I see is that the entire system is crawling. I dial an extension and it might be 20-30 seconds before it even rings. Same for Ring groups, even nested ones. i.e. ring group 500 calls ring group 501 if 500 doesn’t answer in 10 seconds. so its 20 to 30 seconds between each segment of the dialing process.
At home where the gateway worked and I could dial out this was not a problem. So my question is, why would the system slow down because one of the ETH isn’t working when it should not even be paying attention to that ETH. This sort of problem may still exist even if I buy the xact appliance.
Posts: 2
Participants: 2