@CGHS_NetAdmin wrote:
Working to replace a cisco CM (v9.4) system to FreePBX (v14.0.1.36 / Asterisk 15.1.5).
Have several issues:
Current trunks are MGCP that are part of a cisco 2921 gateway. Looking for Asterisk module “chan_mgcp.so” to load and show as part of “Trunks” (Create new trunk). We are also looking to change the MGCP T1 trunk to SIP (vendor dependent).
Access to older intercom system that runs off an “analog” card in the cisco 2921 gateway. Found a route pattern “5.#00” that routes to “AALN/S0/SU2/0@CGHSNC_Voice_GW.cghs.crusaders”.
Tech note: on cisco IP Phones (Model 79XX), the “Display Name” when creating extensions is only 11 characters. The extension number is what cisco CM puts here, and a “SpeedDial” button is “labeled” for the actual user display name. Also, the “Secret” 32-charachter sequence is limited to 31-charachters.
Any help here is worth while to move this project along.
Geoff Zieman
Senior Network Engineer
Digitz Computers - Raleigh, NC
…on site at Cardinal Gibbons High School
Posts: 1
Participants: 1