@lpiekarski wrote:
Hi All,
I have this one installation that started acting weird, nothing major yet or that I have noticed.
Each time I make a change, edit anything that normally would trigger the “Apply Config” to show up, it doesn’t anymore.It started with FreePBX 13.0.197.22 and now after upgrading to FreePBX 15.0.17.17 its still happening, also upgraded the distro to SNG7.
The only workaround that I found to work is, in Advanced settings set: “Leave Reload Bar Up”.
I also did a fresh install and restored from backup and the error seem to follow the config.
Any suggestions greatly appreciated.
I have two servers running:
— PRODUCTION —
PBX Version:
13.0.197.22
PBX Distro:
10.13.66-22
Asterisk Version:
13.29.2— LAB —
PBX Version:
15.0.17.17
PBX Distro:
12.7.8-2012-1.sng7
Asterisk Version:
13.38.1
Posts: 1
Participants: 1